Billyjack187

After scrounging up enough cash to finally finish my type II swap the damn thing wont fire up. It cranks over but no spark. I did all the preliminary tests I could. My fuel pump is new and yes working fine, the only mod I really had was to splice the cyp/ckp sensor wiring...easy enough. But heres the kicker, while checking the icm/igniter I noticed I had 12 volts at all but two wires for the cylinders...wiring diagram says the 1 & 2 had o volts. I do have fuel, and yes my main relay works. I have tracked it down to the igniter not putting out power to 2 circuits...and without the #1 being recognized by the ecu it will never start...any ideas? I suspect a bad wire but would a blown 25 fuse cause this as well? I think if the icm fuse blows it would be common to ALL cylinders...correct? My last places to check is the splice at the cyp/ckp and the ecu...any REAL help would be appreciated. I am a wrench so I have checked the standard stuff, its a COP system so it is pretty straight up. Just baffles me why 2 out of 6 wires have voltage...f@ck my life.