91LSplendid

I am just wondering if my RPM's are normal?

I timed my rpm's this morning - all rpms are while in Park & it was approximately 40 degrees outside

1700 rpm @ start up
1250 rpm @ 1 min 30 secs
1000 rpm @ 3 minutes
900 rpm @ 5 minutes

Eventually, the rpms settle down to 650-700.

Thanks.
.

__________________
John aka: Splendid

'91 LS - Golden Glow Pearl Clearcoat w/ Ivory Leather 94K miles



Mods 7 Spoke OEM Machined Rims, Sunroof Tilt, Armrest w/ Cupholder, Iggee Seat Covers w/ Controls mod. UnMods Removed tint

Gallery Pictures Link

DIY's
1) How to Install Iggee Front Seat Covers
2) Iggee front seat covers w/ seat controls mod
.

 

dumplin101

same here bro, beside the fact that my rpm stables out about 4-5k. maybe want to try and seafoam that beast

__________________

TonyTheBullet

Mine starts off at 2000 rpm and takes about a couple of minutes to settle down to under 1K. Usually it takes longer if its cold outside, sometimes as long as 5 minutes. I tried to adjust my IACV but couldnt get the cover off, thanks to my feeble arms.

fuzzy2k3

same here
takes 5 mins of driving till it settles (i think usually right after the fan kicks in for the first time)

telafonic

All autos?^

My auto was a little high under cold conditions, but the manual I have now is quite a bit lower. But that is normal.

__________________

sam o nela

1700....then drops to 1500,

then 1200, 900, 1200, 900, 1500, 750, 1200, 900, 1500, f*k it....put it in drive....































( sorry I couldnt resist)

__________________


<Monocolor Paint Scheme> <JDM Clear Corners> <Cleared out Rear Turn Signals>
<Acura Caliper Grill Emblem> <Independent Yellow Fog Mod> <15% Tint>
<Iggee Seat Covers> <EL Reverse Glow Gauges> <Dimmer Mod>
<Ford Taurus Cupholder Mod> <CC Tunk Light Mod> <Fut Short Throw Shifter>
<Custom CAI> <AEM Bypass Valve> <OBX Headers>
<Magnaflow High Flow Cat> <Dynomax Super Turbo Muffler>
<Drilled/Slotted Rotors> <Painted Calipers> <Axxis Metal Master Pads>

dumplin101

^ haha patients is a virtue. but that jumping rpm does not sound to good

__________________

sam o nela

I know I was kidding...I have a manual G1...but I'm well aware of the bouncing idle from both generations

__________________


<Monocolor Paint Scheme> <JDM Clear Corners> <Cleared out Rear Turn Signals>
<Acura Caliper Grill Emblem> <Independent Yellow Fog Mod> <15% Tint>
<Iggee Seat Covers> <EL Reverse Glow Gauges> <Dimmer Mod>
<Ford Taurus Cupholder Mod> <CC Tunk Light Mod> <Fut Short Throw Shifter>
<Custom CAI> <AEM Bypass Valve> <OBX Headers>
<Magnaflow High Flow Cat> <Dynomax Super Turbo Muffler>
<Drilled/Slotted Rotors> <Painted Calipers> <Axxis Metal Master Pads>

Legend4Lyfe

1500 rpm @ start up
1250 rpm @ 1 min 30 secs
1000 rpm @ 3 minutes
900 rpm @ 5 minutes

then after 10 minutes it usually idles at the 0-100 mark (really quite, sometimes i think the car is off) is that good for the car.Also one time it was idling at the 0-100 mark and shut off while at a stop light, is that a problem.

shtewps

omfg that was good... same here, exactly the same.

__________________

brynosaur

thats not normal

__________________
www.myspace.com/thebestbryan
BHG free since 2003
95 L coupe 4AT in cashmere silver
60a urethane mounts
FL tie bars (newly installed)
sr5guy stage III ecu
GB Xdrilled/slotted front n rear
rebuilt top end (~20k on it so far)
weapon r + cold air extension
5wire 4awg ground kit

ptan1968

Your rmp is a little higher than mine @ start up:

1250 rmp @ start up
900 rmp @ 2 min
650 -700 rmp @ 4 min 20 secs and settles

I know this is summer time, but in winter time my rmp @ start up was almost the same as yours.

It's all normal.