DSL

crank pulley only

$150 shipped

not using anymore because i did the 3.5 swap.

__________________

'01 3.5l rl engine- 6 speed swap done!, type2- cams, valve springs/retainers, and intake manifold.
ground control, koni, addco-front & rear, mls copy, 18" volk III
rm racing intake, gasket match ported exhaust manifold, light weight pulleys, telion chip, tranny cooler

and a bunch of door dings ~from haters

 

Edify

Someone should definitely pick this up asap. One of the best bang for buck mods! Especially if your using the heavy @$$ Type II pulleys.

-Ed

__________________
Custom CAI - sr5guy stage II chip - EGR Block - TB Bypass - Blackend's Damper - Custom 2" Y Pipe - Magnaflow Cat - 2.5" B Pipe - Type II IM - Labrat Crank Pulley - NA1 NSX Rims - ME 6000k HID. 14.99 @ 94.12 before manifold, pulley, & rims.

Though I've fallen to the Dark Side!

mellofelow

Hmmm... Where are you in LA? 626, 562, 714 areas?

__________________

STROMUNG end of summer '08 GB

DSL

ktown.. very close to downtown

__________________

'01 3.5l rl engine- 6 speed swap done!, type2- cams, valve springs/retainers, and intake manifold.
ground control, koni, addco-front & rear, mls copy, 18" volk III
rm racing intake, gasket match ported exhaust manifold, light weight pulleys, telion chip, tranny cooler

and a bunch of door dings ~from haters

DSL

SALE PENDING!!! buyer wants a faster LEGEND!!!

__________________

'01 3.5l rl engine- 6 speed swap done!, type2- cams, valve springs/retainers, and intake manifold.
ground control, koni, addco-front & rear, mls copy, 18" volk III
rm racing intake, gasket match ported exhaust manifold, light weight pulleys, telion chip, tranny cooler

and a bunch of door dings ~from haters

mktng

what gains would you see from something like this?

__________________
KA7 & Inspire

Edify

The whole set supposedly gives 9-10hp/tq(labrats dyno techniques were questionable). This being about 70% of the weight savings, maybe 7hp/tq? Though I bet weight savings on the crank pulley is the most beneficial. Better throttle response/gas mileage.

-Ed

__________________
Custom CAI - sr5guy stage II chip - EGR Block - TB Bypass - Blackend's Damper - Custom 2" Y Pipe - Magnaflow Cat - 2.5" B Pipe - Type II IM - Labrat Crank Pulley - NA1 NSX Rims - ME 6000k HID. 14.99 @ 94.12 before manifold, pulley, & rims.

Though I've fallen to the Dark Side!

mellofelow

Met with DSL and picked up the pulley today. Super guy and even let me test drive his 3.5 swap with Spec clutch II setup. YowZa! That clutch was tight and the engine screams.

Thanks! So fortunate that this forum has the classiest enthusiasts around.

__________________

STROMUNG end of summer '08 GB