My dual stage setup idea:
Primary shot (40) engages @ WOT. Stays on as long as pedal is floored
Secondary shot (40) uses an RPM WINDOW switch. Comes on around 4200RPM. & only @ WOT. Cuts off @ 6400.
Both solenoids are switched to a master arm & full throttle switch.
Will this setup work well???
Open to ideas of different ways to run this setup, &/or ways to modify mine.
Thx in advance
Eric
Primary shot (40) engages @ WOT. Stays on as long as pedal is floored
Secondary shot (40) uses an RPM WINDOW switch. Comes on around 4200RPM. & only @ WOT. Cuts off @ 6400.
Both solenoids are switched to a master arm & full throttle switch.
Will this setup work well???
Open to ideas of different ways to run this setup, &/or ways to modify mine.
Thx in advance
Eric
