Acura Legend Forum banner
1 - 3 of 3 Posts

· Registered
Joined
·
5 Posts
Discussion Starter · #1 ·
I only recently purchased the used 91 Acura Legend for 3K and the driver's seat had been modified, I guess to fix the problem that it now rocks back and forth like a rocking chair!! :giggle: I found a crushed up, chewed up piece of board underneath the seat, which obviously was the support. Well, what I need is some advice, tips, ideas, instructions or suggestions on how I can fix it so that when I press the gas, I don't go flying backwards grabbing onto the gear and pulling it all the way to D1!! :giggle: Looking at just replacing the whole seat.!!!! :rolleyes:
 

· 'hood Garage
Joined
·
3,177 Posts
1. Go to a junk yard and get a new seat and bracket.

2. Go to a junk yard and try to get a bracket and use original seat.

3. Buy a set of racing seats and install. Sparco, Recaro, Bride, etc. Recaro makes the most sophisticated looking seats if you don't want a race look.
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top