Acura Legend Forum banner

1 - 6 of 6 Posts

·
Registered
Joined
·
256 Posts
Discussion Starter #1
A couple of months ago the legend went in for a bunch of work including a new clutch. I read up on the 5spd clutch and flywheel swap and decided to go through with it. Soon after the break in period for the clutch was over I noticed something just wasn't right. At around 2k-2.5k rpm in any gear but first, if I push the throttle anywhere past half, the car hesitates and jerks as if the clutch is slipping. Has anyone else had this problem?
 

·
Registered
Joined
·
256 Posts
Discussion Starter #2
bump.
 

·
Registered
Joined
·
256 Posts
Discussion Starter #4

·
Registered
Joined
·
6,027 Posts
did you put a new throwout bearing in?

are you sure your slave cylinder is properly bled?

is your clutch pedal adjusted properly?

were the pressure plate and flywheel resurfaced before you installed them?
 

·
Registered
Joined
·
256 Posts
Discussion Starter #6
did you put a new throwout bearing in?

are you sure your slave cylinder is properly bled?

is your clutch pedal adjusted properly?

were the pressure plate and flywheel resurfaced before you installed them?
it was done at a shop that i used to work for and i was there when they did everything. the pedel seems to be adjusted fine. the pp and flywheel were both brand new out of the box. could the clutch pedal cause that kind of slippage if it wasnt adjusted properly?
 
1 - 6 of 6 Posts
Top