Acura Legend Forum banner
1 - 4 of 4 Posts
G

·
Discussion Starter · #1 ·
Woud boring a rim from 60mm to 70mm be too much ?

Would 10mm cause the rims to lose structural integrity?

Thanks:)
 

·
Registered
Joined
·
3,728 Posts
If you're boring the center hub opening of the rims, then I think 10mm is fine. with TL rims, they have to be bored from 64mm to 70.1mm that's 6mm, another 4mm shouldn't be that bad. What kind of rims have that small hub?
 
G

·
Discussion Starter · #3 ·
Lexus... I was going to run the 17X8 +50 offset Lexus GS430 rims but got some 18's instead....

I think the GS 430 rims would look verry nice on a 4/2 Door Legend... and w/ the 8 inch width..:)



Look at these for the LS 430

18X9 W +45 offset though...

 

·
0000$$$$0000####0000
Joined
·
4,926 Posts
Thai.95LCoupe said:
Lexus... I was going to run the 17X8 +50 offset Lexus GS430 rims but got some 18's instead....

I think the GS 430 rims would look verry nice on a 4/2 Door Legend... and w/ the 8 inch width..:)



Look at these for the LS 430

18X9 W +45 offset though...

Those last pictures of the JDM GS430 18" rims are nice. I saw then on ebay and for a fairly cheap price too. If/When I ever get a GS400/430, those rims will be the daily drivers with 20" rims for show :D
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top