Looks real good Aaron, I wanna know if there's a difference between cross drilled slotted rotors and the Dimpled slotted ones? Your car is the shiznit Aaron, I just wish I had me a nice coupe.
Dimpled/Slotted Brembos Installed
G
2
I finally got my new brakes on that I got from Wood over at Raceconcepts. He was great and I got my PBR MetalMaster pads and zinc plated Dimpled/Slotted Brembo/Bradi Rotors for $324 shipped. I'm still breaking them in right now so I can't really comment on the added performance but for me its so much better right now.
I knew that something had to be seriously wrong with my brakes that I had one previously because when I would press down on the pedal almost nothing would happen and it was way to soft. So we bled the brakes which hepled a lot. Then upon inspecting the rear caliper mounting brackets we found that the pins were rusted in so basically the rear calipers hadn't been working at all
. Anyways, we just ran some solvent through there and cleaned all the dirt and everything out so that it's like new. Installation was pretty straightforward, but it took us like 8 hours cause of the little problems that we ran into and the two front big bolts were really hard to take off.
I'll make another post when I finish braking them in in like another 475 miles. Then I rip it up.
Here is the front:
![]()
Here is the rear rotor:
![]()
I knew that something had to be seriously wrong with my brakes that I had one previously because when I would press down on the pedal almost nothing would happen and it was way to soft. So we bled the brakes which hepled a lot. Then upon inspecting the rear caliper mounting brackets we found that the pins were rusted in so basically the rear calipers hadn't been working at all
. Anyways, we just ran some solvent through there and cleaned all the dirt and everything out so that it's like new. Installation was pretty straightforward, but it took us like 8 hours cause of the little problems that we ran into and the two front big bolts were really hard to take off.I'll make another post when I finish braking them in in like another 475 miles
. Then I rip it up.Here is the front:
Here is the rear rotor:
