Acura Legend Forum banner
1 - 1 of 1 Posts

· Registered
5 Posts
Discussion Starter · #1 ·
I've managed to completely take everything loose for my timing belt job but i can't get the socket off of the bottom crank pulley. in the manual it says to use a chainwrench to keep the pulley from spinning. i've purchased two so far and none of them are long enough to wrap around the pulley. I have a 91 Legend. Any suggestions or address to where i can buy a chainwrench long enough to hold the bottom pulley in place while i unbolt the bolt. Or even better, where i can purchase the tool that the manufacturer uses. Acura parts says they can't sell me one. And i refuse to stick a screwdriver throught the crank pulley ( don't want to mess up the oil pan).
Please. i really need to do this before spring break is over!:( :confused:
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.