did you make sure your e brake is all the way down...lol.. seriously that woulda been the first thing i'd check. how about the fluids... checked?

 

sorry i meant the rear brake lamp went out....so i need to change out the bulb, but do i access it from the trunk or the backseat?

 

sorry i meant the rear brake lamp went out....so i need to change out the bulb, but do i access it from the trunk or the backseat?

The trunk

there should just be some screws near the back of the trunk... it might be unerneath the trunk padding. Its pretty simple... just look for it, I'm sure you can figure it out

 

Rear Brake Light

I would assume you are talking about the 3rd brake light since you asked about getting to it through the back seat. Whichever brake light bulb needs replaced, you will access it through the trunk.

For the 3rd brake light there are 2 nuts attatched to 2 studs passing through the rear dash panel. Remove them, unplug from the wire harness, get in back seat and remove the 3rd brake light. Twist the bulb socket to get to the bulb, remove and replace with new bulb. Re-install in reverse.

Tail light bulbs are accessed from the trunk also. Remove the knob screw holding the tail light cover inside the trunk. Unscrew the bulb socket containing the blown bulb and replace.

Good Luck

:2cool:

 

Well this is very strange... Driving to work today, 3rd gear worked... and the tranny worked perfect.

Driving back home from work... I had the same problems.

 

Well this is very strange... Driving to work today, 3rd gear worked... and the tranny worked perfect.

Driving back home from work... I had the same problems.

I certainly would'nt have those checked out right away.

:2cool:

 

I certainly would'nt have those checked out right away.

:2cool:

sorry man I had a few windows open, and I posted in the wrong thread.

 

Like Cole said, here's your way. It's really simple to replace the bulbs.

1. Open your trunk.
2. Then you can see a cover on both sides of the taillights.
3. The cover is helded with 2 screws.
4. On both sides you can see black screws on each side.
5. After unscrew you can see all bulbs and their sockets.
6. Unscrew it and press the bulb by turning.
7. Replace the bulbs you need and your're done.

At least some pics how's the taillight looks like after removing the cover. Good luck. -Mike