Acura Legend Forum banner
1 - 1 of 7 Posts

· Registered
1,292 Posts
I agree with jno2968326 a matter of fact I put a master cylinder from an 88L coupe (w/ABS) into my 90LS sedan (w/ABS) this past summer. I checked out using a non-ABS master cylinder, and it was DEFINITELY not a match.

By the way ....when you swap master cylinders (or put a new one in) be sure to adjust the push-rod properly the point where there is NO pressure on the push-rod when you re-install the master cylinder. If there is any pressure at all, you will have trouble with the brakes constantly building up pressure and applying it to the wheels.
1 - 1 of 7 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.