Acura Legend Forum banner
1 - 3 of 11 Posts

· Registered
Joined
·
12 Posts
Discussion Starter · #1 ·
Someone had a similar question to this problem but it was never answered:
I just parked my car too far past a parking lot stop...and my front bumper scraped against the stop. After I pulled out...I noticed that my signal lights and my hazard lights are completley dead. Does anyone have any idea what could be wrong? If a wire got pulled out what should I look for? Any help would be great as I know there must be a correlation between what I did with the front bumper and the lights suddenly not working.

Thanks!
 

· Registered
Joined
·
12 Posts
Discussion Starter · #4 ·
Thanks for the suggestions. I took both of your advice and checked the fuses. I couldn't find the fuse for the turn signals under the hood...are they labeled as something else. I did find the fuse for the hazard signal and it was blown. I put in a new fuse and the hazard and the blinker lights were working fine for about 10 seconds...but then it blew again. Any suggestions? Is this a case of wiring now?
 

· Registered
Joined
·
12 Posts
Discussion Starter · #7 ·
I have not done any electrical work to it at all. I did as Merlin suggested and I isolated the problem to a degree. I found the signal light fuse and they are fine. But as stated the hazzard fuse was blown. When I put in a new hazzard fuse and put on my left blinker it is fine...but when I either put on the hazzards or use the right blinker the fuse blows right away.

Do you think then this is the right blinker light as you stated before needing to be replaced? Sad thing is...I can't even get to it. I tried to...removed the cover below the light and everything as suggested in the manual but still having trouble. I just want to make sure it is the light and not wiring.
 
1 - 3 of 11 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top