Acura Legend Forum banner
1 - 1 of 1 Posts

· Registered
34 Posts
Discussion Starter · #1 ·
I had my legend up on a lift the other day and both outer tie rod bushings are starting to look bad. The steering isn't affected yet, but they need to be fixed. It looks like all I need to do is
remove the cotter and castle nut
take out the bolt
unscrew from the inner tie rod
replace with new rod/bushing
pay for an alignment

Is that right?
Am I going to need any special tools? I didn't see a good procedure in my service manual.

Any advice on greasing and where to buy the parts?
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.