Acura Legend Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
39 Posts
Discussion Starter · #6 ·
LPB said:
Using the 3M moulding tape to retape an emblem, esp a series of letters, is an exercise in futility. It is extremely difficult to cut the adhesive w/o some of it showing around the edges. You often have to use two strips of moulding tape and anywhere there are gaps, there is a tendency over time for dirt to infiltrate and cause the emblem to separate from the tape. The correct procedure is to have used a release agent on the original emblem so as to not damage the backing. Then use clear emblem adhesive to reglue. This glue, however, will damage paint. The short response is to just buy a new emblem.
LPB,

Can the clear emblem adhesive be used to glue back on emblems with no backing? Also who makes the clear adhesive and where can I buy it? Thanks.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top