Acura Legend Forum banner

window problem

1.2K views 9 replies 7 participants last post by  unarmdragon  
#1 ·
yes i did search before i posted this... my passenger front window rolls down ok but goes up slow and has been getting stuck especially after it rains....now i read the posts on hear and shot some silicone spray down in the window sill. This didn't do much except make my window growl as it slowy comes up. I don't think it is the motor. What does the regulator do? The previous owner said that it just needs a new peice of trim that the window glides along? Any thoughts on pinpointing the problem?
 
#3 ·
Yes...check alignment.

My windows used to "hop", especially after it rains.

Along with thoroughly lubricating the entire track (both front and rear), make sure you clean them as you go as there's probably a bunch of "muck" in them from the years.

~Eric
 
#5 ·
I never had any problems like this, but my driver's window did pop out of it's channel a while ago. I tried to re-align it with no success....

My driver's windows still doesn't roll down, and I'm quite sure I just need to re-align it, or replace the channels but I can't figure out how to get the window out once the door panel is removed, so I need help now too :)
 
#6 ·
I've recently had problems wth my window popping out of its channel and was not running too smooth. I took the interior part of my door off and found that my regulator/motor was loose. I believe there is about 4 bolts the fasten the motor to the door and i think there is 2 more that hold the regulator up (i'm going by memory). Just make sure you re-alligned my window properly by pushing the window up against the side of the door and tighten the bolts. Then spray the rubber moulding where the window runs. It should solve the problem. Hope that helps.
 
#7 ·
I will definately try that, I looked at my regulator with the door panel off and didn't notice how tight the screws were. The real problem I'm having though is I can't find out how to get the glass out. It is completely "sitting" in my door frame. How can I remove my glass and window run channels, inspect and realign them then re-install into the door panel?
 
#10 ·
i just switched the window regulator for $120 yesterday.. my driver side wouldn't roll down.. it stops half way and keeps making a clucking sound.. if i pushed it down along with holding the roll down button it goes down.. so i decided to go to a shop to change the regulator.. after that it works perfect.. hope this helps..