The Acura Legend & Acura RL Forum - Search Results
Acura Legend Forum Acura Legend Forum
 

Auto Insurance

» Featured Product
Wheel & Tire Center

Go Back   The Acura Legend & Acura RL Forum > Search Forums

Acura-Legend.com is the premier Acura Legend Forum on the internet. Registered Users do not see the above ads.
Showing results 1 to 25 of 26
Search took 0.02 seconds.
Search: Posts Made By: red4re
Forum: Parts Wanted 02-25-19, 05:25 PM
Replies: 0
Views: 206
Posted By red4re
Transmission Part

Looking for new or used 1st gear(low) for 1988 Legend 5speed LS Coupe
Part number 23421-PG1-000. This gear is on the countershaft in the 5 speed transmission. Please Help

John
Forum: First Generation Legend (1986-1990) 05-05-11, 11:22 AM
Replies: 4
Views: 868
Posted By red4re
Anyone Parting out 1st Gen. Legend

Looking for some parts for my 1988 Legend LS 2 door. The driver side outside metal piece (stainless) that frames the windshield. My came off at around 80mph, probably because of improper...
Forum: First Generation Legend (1986-1990) 04-27-11, 09:56 AM
Replies: 3
Views: 978
Posted By red4re
How many miles on the engine? If you decide to...

How many miles on the engine? If you decide to part out, I need a number of parts.
Forum: First Generation Legend (1986-1990) 04-29-08, 07:33 AM
Replies: 8
Views: 812
Posted By red4re
Front vibration when braking hard

1988 LS, when I brake hard the steering wheel picks up a vibration or shimmy. Nothing is loose when I check the front suspension. Could this be the ABS causing the problem. CV joints, ball joints...
Forum: First Generation Legend (1986-1990) 11-04-07, 05:57 PM
Replies: 7
Views: 794
Posted By red4re
Steering rack grease

I have to replace the left boot on my steering rack and the manual indicates a special grease from Acura. I'm surprise that regular wheel bearing grease won't work. There are not any Acura dealers...
Forum: First Generation Legend (1986-1990) 08-07-07, 11:16 AM
Replies: 5
Views: 447
Posted By red4re
The problem is not that the battery is low. I am...

The problem is not that the battery is low. I am sure is is electrical I just don't know where it is that causing this. I don't think it is fuel related as when I push the accelerator hard the car...
Forum: First Generation Legend (1986-1990) 08-06-07, 01:33 PM
Replies: 5
Views: 447
Posted By red4re
More Problems looking for good advice

I was replacing the alternator and shorted the wire which blew the 70amp fuse. I replaced the fuse. The car idles smoothly but when I drive the engine cuts out, if I accelerate hard it runs ok. I...
Forum: First Generation Legend (1986-1990) 08-02-07, 01:43 PM
Replies: 2
Views: 2,456
Posted By red4re
Help, Timing Belt Questions

1988 Legend LS, 2 door, 5 speed. I am in the process of installing a new timing belt. I need to know the marks to align the cams, crank. On my crank timing belt drive pulley there is a small dot...
Forum: First Generation Legend (1986-1990) 07-08-07, 10:53 PM
Replies: 4
Views: 588
Posted By red4re
Question Radiator Questions

I have the radiator out of the car, not an easy job because of the difficulty in removing the fans. Not enough clearance. I'm trying to decide is I should find a radiator shop and have the core...
Forum: First Generation Legend (1986-1990) 07-06-07, 12:36 PM
Replies: 2
Views: 857
Posted By red4re
Cool I have to replace the radiator

I am going to replace the radiator on my 1988 LS coupe. How much has to be removed to get it out of the car? Who has the best radiator/price.
Forum: First Generation Legend (1986-1990) 06-15-07, 12:28 PM
Replies: 5
Views: 1,270
Posted By red4re
Angry Power Steering Fluid Boiling

I opened the hood after a 30 minute drive and found that the P/S fluid was leaking around the cap. I took off the cap and saw that the fluid was foaming and very hot. What would cause this?
Forum: First Generation Legend (1986-1990) 06-07-07, 06:22 PM
Replies: 12
Views: 782
Posted By red4re
Angry Weather hot, car too hot

250K miles on 1988 LS, replaced water pump 50K miles ago, water toped off in radiator, both fans working. No water leaks. a/c not on the temp goes near red zone on gage. What do I need to check? ...
Forum: First Generation Legend (1986-1990) 06-04-07, 04:15 PM
Replies: 5
Views: 778
Posted By red4re
Unhappy Running hot with a/c on

In Las Vegas 101 outside, With the a/c on the temp gets very close to the red.
Water pump replaced with timing belt 20K miles ago, I have replaced a/c fan, no visible water leakage. Any ideas? ...
Forum: First Generation Legend (1986-1990) 04-13-07, 11:11 AM
Replies: 6
Views: 720
Posted By red4re
I did as you suggested and ordered the seal from...

I did as you suggested and ordered the seal from Acura. When installing the seal I am assuming that the seal bottoms out in the triangle shaped rear seal retainer. That is how I have installed it. ...
Forum: First Generation Legend (1986-1990) 04-05-07, 09:50 PM
Replies: 6
Views: 720
Posted By red4re
Rear Main Seal

I pulled the transmission again and found that the (new) rear main seal was bad. The inside diameter of seal had deformed and that was the cause of the oil leakage. Is there a difference in the...
Forum: First Generation Legend (1986-1990) 04-04-07, 11:11 AM
Replies: 6
Views: 720
Posted By red4re
Unhappy Need help, big oil leakage

I recently replaced the clutch pressure plate, disc and faced the flywheel. Also I replaced the rear main seal. A very difficult job indeed. Started the car, no oil leaks. After driving to Las...
Forum: Engine & Performance Modifications 02-26-07, 02:12 PM
Replies: 1
Views: 1,774
Posted By red4re
o2 sensor replacement

Is it important to replace the two o2 sensors, I have 250,000 miles on the car. Looking at the one nearest the firewall how do you get it out. Looks like the steering rack support would have to be...
Forum: First Generation Legend (1986-1990) 02-22-07, 06:49 PM
Replies: 3
Views: 834
Posted By red4re
Help-I am having trouble re-installing my manual transmission

I hope someone has good advice on the best way to line up the splines on the clutch disk and transmission. Is the tranny supposed to go into place easy, or do you have to force it by tightening the...
Forum: First Generation Legend (1986-1990) 02-04-07, 02:20 PM
Replies: 2
Views: 619
Posted By red4re
Question CV Joint advice

1988 Legend LS 2 door, I am doing a clutch replacement and have the CV axles removed so I thought this might be a good time to repalce them with new ones. Car has over 250K miles. Rockauto has new...
Forum: First Generation Legend (1986-1990) 01-24-07, 06:12 PM
Replies: 1
Views: 480
Posted By red4re
Installing Clutch Kit

1988 Legend LS 2door with 250,000 miles. I am planning on installing a new clutch kit and have been checking on the internet for best prices, etc. Prices run from $206 for Sachs brand and $245 to...
Forum: First Generation Legend (1986-1990) 01-19-07, 04:12 PM
Replies: 1
Views: 1,266
Posted By red4re
Angry Manual Transmission getting into gear problems

1988 Legend LS over 200K miles, manual tramission. The problem is when I start the engine I can not shift into any gear, grinding if I push it. I replaced the clutch slave and Master cylinder, bled...
Forum: First Generation RL (1996-2004) 11-17-06, 01:34 PM
Replies: 0
Views: 441
Posted By red4re
Unhappy Clutch Problem Not From Slave/Master Cyl

1988 Legend 2 door. After replacing the clutch slave and master cyl and bleeding the lines I was still not able to get the car into gear. Today I needed to move the car out of the garage and so I...
Forum: First Generation Legend (1986-1990) 11-15-06, 07:25 PM
Replies: 6
Views: 612
Posted By red4re
Cool Clutch Problem

The clutch slave and master cylinder are new, I did not bench bleed the Master did not have any instuctions to do this. I drove from St. George, Utah to Las Vegas and drove around their several days...
Forum: First Generation Legend (1986-1990) 11-14-06, 11:02 AM
Replies: 6
Views: 612
Posted By red4re
Question Makes No Sense

1988 LS 2 door with 250K miles. I have been having trouble with clutch engagement. Replaced both slave and Master cylinder, bled the system first with friend depressing pedal and then using vacuum...
Forum: First Generation Legend (1986-1990) 10-25-06, 12:03 PM
Replies: 1
Views: 1,021
Posted By red4re
Help, clutch master cylinder removal

1988 Legend 2 door, 285 k miles. Any tips on how to removel clutch master cylinder. This looks almost impossible.

John
Showing results 1 to 25 of 26

 
Forum Jump
Powered by vBadvanced CMPS v3.2.2

All times are GMT -4. The time now is 01:06 AM.



Powered by vBulletin®. Copyright ©2000 - 2019, Jelsoft Enterprises Ltd.
Search Engine Friendly URLs by vBSEO 3.6.0
vBulletin Security provided by vBSecurity v2.2.2 (Pro) - vBulletin Mods & Addons Copyright © 2019 DragonByte Technologies Ltd.
© AutoGuide